If you get an error message like this:
I don't know how to ...
..it means you used a word, inside your procedure, that Lynx doesn't understand. Words that Lynx knows consist of its built-in vocabulary and some new words that you taught Lynx in one specific project, for example:
- the procedures you defined,
- the page names,
- the text boxes
- slider names
- sounds.
If a word, inside your procedure, is none of these, Lynx will not be able to understand it.
If this error message refers to a procedure that you just wrote, the most common cause is the omission of the word to (followed by a space) and the name of your procedure on the 1st line or end on the last line by itself. See this example:
To repeat: Every procedure should have a definition (the word to followed by your procedure name) and the ending (word end). Both the definition and the ending should go on a separate line.